The Deep – Deep Pour Resin Kit – 3 Gallon Kit

$318.00 $290.00

Specifically designed for river tables, large voids, deep casting, and much more. Designed to have no bubbles, be crystal clear, and incredibly hard when cured. Very low heat during curing allows this resin to be pored up to 2” thick and have a very long workable time with very low heat reaction. Heat Resistant-Scratch Resistant- Food Safe- U.V Resistant- Water Resistant – Easy To Clean- Zero VOC

  • Dry To Touch: 36-48 hrs (temperature depending)
  • Light Use: 72 hrs
  • Fully cured: 7 to 10 days depending on temperature
  • Very Low Viscosity – Water like when poured.
  • Long pot-life and workable time.
  • UV Stabilizer added for ultimate UV protection from yellowing.
  • Exceptional bubble release and crystal clear clarity. Looks like water when cured.
  • Low heat reaction in thick deep pours.
  • 3:1 mixture.
  • Compatible for use with most epoxy colors and additives.
  • Manufactured in the U.S.A.
  • Minimal torching required due to fewer bubbles. Sometimes not needed at all

IMPORTANT: This is an advanced deep pour epoxy resin. DO NOT use The Deep – Deep Pour Epoxy in working temperatures above 80°F.

You must take into consideration the volume of epoxy you pour into a void, or river. Pouring too much epoxy into a large area may result in overheating which could result in shrinking, yellowing or cracking. Keeping the work area cool by adding a fan can help reduce the risk of the epoxy overheating if working conditions are above 80 degrees. If you have any questions or concerns about the process please give us a call at (800) 837-5861 or send us an email at

Optimal Working Conditions:

For best results, all materials and working conditions should be maintained at a constant 60°F-75°F. Epoxy Resin is a temperature sensitive material. When cool, it’s thicker and sets slower. When warm, it’s thinner and sets faster. Working in a shop or with material above 75°F, The Deep may set too quickly and become too hot, which could cause it to yellow, distort, shrink or crack. Make sure your room temperatures are in the correct range. If it’s cooler, it’s ok it will just take a bit linger for the epoxy to cure.

Maximum Pouring Thickness:

Max casting thickness can vary depending on a number of factors including shop temp, material temp, mixing quantity, mold material, project dimensions, etc. Larger slabs should be poured thinner than smaller castings to minimize exothermic reaction (heat). Every project is unique, but as a general guideline do not exceed 2” casting thickness on general rivers. We recommend pouring in half inch intervals and torching in between to remove any surface bubbles in the deep pour. In some situations where the pour is wide enough, you can exceed 2″ but we recommend keeping it under 2″ for best results.

Pre Seal Anything You Are Embedding Into The Epoxy Resin:

When casting materials like rocks, leaves, flowers and other substrates, make sure the material is dry and sealed. We recommend sealing any wood or porous surfaces prior to using our Deep Pour Epoxy. We recommend sealing with The Quick quick setting epoxy or The Top – top coating epoxy prior to casting in a Deep Pour.

Epoxy Generates Heat:

CAUTION EXOTHERMIC REACTION: Mixed epoxy generates heat very rapidly the more volume and less space you have. The more you mix, the hotter it will be. It is important to  use directly after mixing. Only mix what you are ready to pour.

Additional information

Weight 450 oz
Dimensions 12 × 12 × 8 in